Author: Er. Mr. M. V.

1. The multiplying factor, as applied to obtain the peak hourly demand, in relation to the maximum daily demand is: A) 1.5 […]

1. An imaginary line connecting projecting edges of all treads & parallel to the slope of stair is termed as A) Pitch […]

1. In PERT analysis, negative slack occurs when A) dummy activities are large in number B) events happen as the schedule. C) […]

1. Formwork stripping time for Beam soffits (props left under) is A) 3 days B) 7 days C) 14 days D) 21 […]

1. Muller Breslau principle in structural analysis is used for (i) drawing Influence Line Diagram for any force function (ii) writing virtual […]

1. In a fillet weld, the weakest section is the A) smaller side of the fillet B) throat of the fillet C) […]

1. The material in which large deformation is possible before the absolute failure by rupture takes place is known as A) Ductile […]

1. Which of the instruments is needed for testing the fineness of the cement? A) Le-Chatelier apparatus B) Vicat’s needle C) Air […]

1. The total depth of the water required by a crop Delta (m) during the entire period the crop is calculated as […]

1. ERS, Envisat, Sentinel and RISAT are example of which type of satellites? A) Optical B) Passive C) Thermal D) Microwave Check […]