- Take representative soil sample of approximately 120 gms passing through 425 micron IS sieve and mix thoroughly with distilled water in the evaporating dish to a uniform paste. The paste shall have a consistency that will require 30 to 35 drops of the cup to cause the required closure of the standard groove.
- Remix the soil thoroughly before the test.
- Place a portion of the paste in the cup above the spot where the cup rests on the base, squeeze down and spread in to position with a few strokes of the spatula as possible and at the same time trim to a depth of 1 cm at the point of maximum thickness.
- Make a clean, sharp groove by a grooving tool along the diameter through the center line of the cam follower.
- Drop the cup from a height of 10 ± 0.25 mm by turning the crank at the rate of two-revolutions/ sec, until the two halves of the soil cake come in contact with the bottom of the groove along the distance of about 12 mm.
- Record the number of drops required to cause the groove close for the length of 12 mm.
- Collect a representative slice of sample of soil approximately the width of spatula, extending from about edge to edge of the soil cake at right angle to the groove in to an air tight container and keep in the oven for 24 hrs ,maintained at a temperature of 105˚C to 110°C and express its moisture content as the percentage of the oven dried weight.
- Transfer the remaining soil in the cup to the evaporating dish and clean the cup and the grooving tool thoroughly.
- Repeat the operation specified above for at least three more additional trials (minimum of four in all) with soil collected in evaporating dish to which sufficient water has been added to bring the soil to more fluid condition.
- In each case record the number of blows and determine the moisture content as before.
- The specimens shall be of such consistency that the number of drops required to close the groove shall not be less than 15 or more than 35.
- Plot a flow curve with the points obtained from each determination on a semi logarithmic graph representing water content on the arithmetical scale and the no of drops on the logarithmic scale.
- The flow curve is a straight line drawn as nearly as possible through the four or more plotted points.
- The moisture content corresponding to 25 drops as read from the curve shall be rounded off to the nearest second decimal and is reported as liquid limit of the soil.
Er. Mr. M. V. Asked question January 11, 2024
Write your answer.
